Club building process

With us you can buy clubs 'off the rack' as with any regular golf shop. These clubs can sometimes feel and perform differently due to a standard way of assembly in the factory.

In addition to the standard clubs, we offer two other options:

  1. Club building with the standard shafts
  2. Club building with custom shafts

In addition, we give a glimpse into the process of club building. You will immediately understand that the costs are slightly higher, but the result is many times better for you!

This is how we make your golf clubs

  • 1: Measure shafts

    Step 1: Measure shafts

    We start with measuring the shafts. It is important to see whether all shafts have the same (top) quality.

  • 2: Selecting the shafts

    Step 2: Select shafts

    In this phase we put the shafts in order per club.

  • 3: Tailoring the shafts

    Step 3: Tailoring

    With a regular goilfset, each golf club has its own length. In this step we make the shafts to the correct length.

  • 4: spinning

    Step 4: spinning

    With a golf set that comes from the 'factory', the logos on your shafts are all the same. This is not the case with us. We find out where the spining is per shaft for the optimal result

  • 5: place ferrules

    Step 5: Installing ferrules

    These are the sleeves on the shaft that are attached to your club face. This makes the transition from club face to shaft more beautiful.

  • 6: To balance

    Step 6: Balancing golf clubs

    "Swing weight is an important factor and method for making the club feel as natural as possible to you during the swing.

  • 7: head glue

    Step 7: Glue the cup to the shaft

    The head is glued to the shaft with a special component glue.

  • 8: to dry

    Step 8: Drying

    The glue with which the head is attached to the shaft takes about x hours to dry. So patience is a virtue.

  • 9: Placing grips

    Step 9: Placing grips

    It's already starting to look like a golf club. After the drying process we can start placing the grips.

  • 10: Finish off

    Step 10: The finish

    Remove the glue residue and polish and check the clubs. We look at the result with pride.

  • 11: Message

    Step 11: The clubs are ready!

    When your golf set is ready to play. You will receive a message from us immediately.

  • 12: Play

    Step 12: Get into the golfcourse

    It is then up to you to practice and get on the track. Enjoy more consistency in your strokes and your distances.

    Lots of fun!